1.0.0 - Create the first schematic 

1.0.1 - Remove Jack from the board (to free up place)
1.0.2 - Remove `JP_NO_Safety` from board to free up spaces (use jumper wire on Fuse and R_sImax instead)
1.0.3 - Adjust text sizes. Add name, board identifier with version, open hardware icon, project site url. Replace `Fuse`'s package to take less place on board.
1.0.4 - Rearrange the 78xx and chevron jumper pads to avoid using vias
1.0.5 - Merge `Net-(P3-Pad1)` to `/bus_connector_2_FET/Bus_Gnd` (with text editor) to have a  consistent GND layer, and add GND layer

Mistakes made at the first production series:
	- The mask is on the wrong side: to match the AVR pins and RJ11 pinout, you have to
		solder these stuffs to the opposite side than the solder mask. But actually to
		have a consistent build, you have to solder everything to the opposite side as intended.
		To fix this AVR pinout should be flipped and RJ11 pinout must be modified to match the mask and component placement.
	- Some labels are unreadable: "Open Hardware", the website url, designer name, Jumper names, some component names.
		This should be written with bigger fonts.
	- Some label is unreadable if components are placed to the intended side.
		Eg.: Q_Inv is completely covered when transistors soldered without elevation gap.
		Move these labels beside of the components placement siluette.
	- TVS rectangle is on the wrong side.
		Square footprint should be on the ground side.
	- RJ11 is a bit too close to the bus pins.
		The connector and inserted AVR panel are touch each other. (That was close... but they fits)

	= But mechanically and electrically the design works! That's a win.